Experience the enhanced convenience and versatility of the new DENALI CANsmart Controller GEN II, designed to seamlessly integrate with your BMW motorcycle’s CAN bus electrical system. This advanced controller simplifies the installation of accessories with a true plug-and-play setup and provides centralized control for up to four accessories. With the intuitive BMW "WonderWheel" or CANsmart Accessory Manager Software, you can access dozens of customizable settings tailored to your needs.

The Gen II CANsmart comes preconfigured to operate two sets of DENALI 2.0 lights, a SoundBomb horn, and a B6 auxiliary brake light—each with independent control. Unlike its predecessor, all four circuits now deliver a robust 10 amps of continuous power and can be programmed to support any accessory. The updated model also introduces two valuable features: the ability to modulate auxiliary lights for increased visibility and the option to automatically cancel left or right auxiliary lights when the corresponding turn signal is engaged, enhancing safety and signaling clarity.

Features

• High/Low Sync: Switch auxiliary lights between high and low settings using the factory high beam switch.
• ON/OFF and Dim: Independently control two sets of lights, adjust brightness for day and night with original switches.
• Modulate Lights: Make auxiliary lights flash to increase visibility to other drivers.
• Flash to Pass: Flash high beam three times to make auxiliary lights strobe quickly.
• Cancel with Turn Signal: Automatically turns off the matching auxiliary light when you use the turn signal.
• Inverse Flashing with Hazards: Auxiliary lights flash in the opposite pattern of your hazard lights for better roadside visibility.
• Plug & Play Horn Installation: Easily connect high-power horns like SoundBomb™ without extra wiring or relays.
• Strobe with Horn: Auxiliary lights strobe when the horn is activated—works with both factory and SoundBomb™ horns.
• Smart Brake Technology: Triggers auxiliary brake light during deceleration before you hit the brake lever.
• Flash Pattern Braking: Choose from four brake light flash patterns to make your bike more noticeable when stopping.
• Circuit Function Selector: Assign any accessory to any of the four CANsmart circuits with the software.
• Switched Power Source: Get clean 12V power that turns on/off with your bike’s ignition.
• Delay Time Out: Keep accessories powered for up to 30 seconds after turning off your bike.
• On Board Power: Ideal for powering GPS units, phones, heated gear, or other devices.